[dcf]

Hi Stein…
I’ve got a similar problem…
In the last round of our regional league, two pilots had several problems with their instruments…
the first one lost the signal for a while…and then was ok again…
so the result is that he made two separate tracks. I appended the second one to the first with gpsdump, and everything went in the right way also in FS (except for the kilometers that the pilot lost in his track…)

instead, the second one with a Flytec 5030 lost the signal several times during the flight…but he noticed it. So he was forced to wait near the waypoints to have the satellites back.
Ok…the result is that if you look at the track with Compegps, for example, it has a start and an end with several straight lines to link the holes of the track.
If you open the log with Gpsdump and you save it in Competition Mode, apparently there are no errors (only if you activate “track log filter” appears a window with “Position(s) have been removed during track speed analysis”).
The new igc and kml file for FS are created….but FS recognize only 13 km on 56 total….
…and if you open the kml with google earth, you see all the kilometers of the track…

how to solve it and give the total points earned to the pilot?

p.s.: I’m working on his igc file because i was absent the day of the race… and the file was downloaded with compegps (they told me that with gpsdump was impossible)

Thanks a lot
Davide

[dcf]

OOOhhh….my god…. :-
I checked it twice two days ago to setup the correct time format…. but Vista did not saved it… Now I rechecked it and forced the format….

It goes…. thanks a lot.

[dcf]

Hi Audun, thanks for your reply.

This is the task setting:

take off: radius 400 opens 12:00 close 20:00
start cilinder : radius 5000 opens 14:15 close 20:00 (start of SS)
first tp: radius 400 opens 14:15 close 20:00

and the same for the others tps until the last one that also closes the speed section (ES)

first start gate 14:15 works…

[dcf]

knock knock…. is there anybody …out there……. 🙂

[Author]

Posts